This sleeve will easily change Camber and/or Caster 3.50° on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present. Using a sleeve puller, remove the existing sleeve and install a zero degree sleeve (23199) to determine the required change, then install the correct degree sleeve. Note: Sleeves adjust to a smaller degree on Ford & Mazda 4WD light truck/SUV vehicles.
- Easily change caster / camber or both at the same time
- Clear Zinc coating for corrosion resistance
- Recommended Tools: 77880 - Sleeve Puller
- Front Adjustment Range RWD: Camber/Caster ±3.50°
- Front Adjustment Range 4WD: Camber/Caster ±2.75°
- Required: 1 per wheel
VEHICLE FITMENTS:
Ford: Bronco II 1989 - 1990
Ford: E-150 2003 - 2014
Ford: E-150 Club Wagon 2003 - 2005
Ford: E-150 Econoline 1992 - 2008
Ford: E-150 Econoline Club Wagon 1992 - 2002
Ford: E-250 2003 - 2014
Ford: E-250 Econoline 1992 - 2002
Ford: E-350 Club Wagon 2003 - 2005
Ford: E-350 Econoline 1992 - 2008
Ford: E-350 Econoline Club Wagon 1992 - 2002
Ford: E-350 Super Duty 2001 - 2014
Ford: Econoline 1999 - 2006
Ford: Econoline Van 2010 - 2014
Ford: Econoline Wagon 2010 - 2014
Ford: Excursion 2000 - 2005
Ford: Explorer 1991 - 1994
Ford: F-150 1987 - 1996
Ford: F-250 1987 - 2009
Ford: F-250 Super Duty 1999 - 2015
Ford: F-350 1987 - 2015
Ford: F-350 Super Duty 1999 - 2015
Ford: Ranger 1990 - 1997
Mazda: B2300 1994 - 1997
Mazda: B3000 1994 - 1997
Mazda: B4000 1994 - 1997
Mazda: Navajo 1991 - 1994